GWS PICO RETRACT LANDING GEAR 2 PC/SET
[RG-PM]

GWS PICO RETRACT LANDING GEAR 2 PC/SET

 

 

SPECIFICATION:

BODY:	WIRE:	TOTAL WEIGHT (1 pcs) :
22.5X7.0X4.5(mm)	1.6x150 (mm)	3.5 g (0.12oz)
8.86X2.76X1.77 (in)	0.63x5.9(in)
0.98g (0.03oz)	2.4g (0.08oz)

SERVO REQUIRED:

GWS PICO+

GWS NARO series

(Use a servo that has 1kg-cm or more torque to operate the retract gears properly. Thus NARO STD servo is not recommended)

PART LIST:

RG-PM x 2 pcs.

Screw x 8

Instruction Manual x 1 pce.

REMARKS:

When the retract gears are at down position (fully open/90 degrees down), the arms of the gears are at anchor situation geometrically. This design will not allow any accidental retraction during landing and taxing and avoid possible damage to aircraft and retract gears.

Install the servo and the retract gears firmly, and make proper linkage as per the drawing shown in order to avoid any error of operation.